RODOGRIP- locking nuts

The RODOGRIP locking nut allows for secure slip-free locking on a threaded shaft. Requires no wedge groove or processing of the threaded shaft. The lock nut is secured by tightening the 3 locking screws. The tightening means that 3 radial brass pins are pressed against the shaft thread without damaging it. The axial load is handeled by the threaded flanks of the nut. The pin and thread are processed in the same operation, leaving a maximum gap of 2 µm between the lock nut and shaft.

---

 

		ANS	For radial clamping on threaded shaft. 3 tightening points. 6 pin slots. Material: 1.075 bronzed. Thread and flat surface: untreated Sizes: M8x0,75 to M200x3
		ANS-LH	Ditto ANS but left threaded Material: Ditto ANS Sizes: M10x0,75 to M80x2
		ANSI ANS-A2	Ditto ANS but stainless Material: Stainless steel 1.4305 Sizes: M10x0,75 to M60x2
		ANSA WAK	For axial clamping on threaded shaft. Round outer diameter. Axial locking Material: 1.075 bronzed. Thread and flat surface: untreated Sizes: M10x0,75 to M80x2
		ANSB	For radial clamping on threaded shaft. Wide series. 3 tightening points. 6 pin slots Material: 1.075 bronzed. Thread and flat surface: untreated Sizes: M15x1 to M80x2
		ANSK	For radial clamping on threaded shaft. Less OD than ANS. 2 tightening points. 4 pin slots Material: 1.075 bronzed. Thread and flat surface: untreated Sizes: M10x0,75 to M95x2
		WSS	Nut socket for ANS, ANSI and ANSB Material: 1.075 bronzed. Thread and flat surface: untreated Sizes: Thread M12 to M70
		WHS	Hook wrench for locking nuts with pin slots. DIN1810. Material: 1.075 bronzed Sizes: Thread M12 to M200